I have a vh-12 into my TD-20, all I get is the open hi-hat. Ive adjusted the off set and looked in the trouble-shooting section and Im lost! Its probably a simple thing too, just new at this stuff!
Results 1 to 3 of 3
Thread: VH-12 not working properly
-
04-12-12, 11:33 PM #1
Contributor
- Join Date
- 12-2009
- Posts
- 62
VH-12 not working properly
-
04-13-12, 12:59 AM #2
Mod Squad
- Join Date
- 11-2001
- Location
- New England
- Posts
- 12,172
Both cables are connected from the VH-12 to the module?
Check the cable from CONTROL OUTPUT on the VH-12 to HH CTRL on the module; that's the one which should be doing the closing. Make sure it's pushed all the way in at both ends, as new plugs/sockets can be very stiff.
Bruce- Roland TD-20+TDW-20, TD-8, SPD-S, PD-105, PD-6/8, CY-5/6/8/12, FD-6/8, KD-7/8, RT-10K, PM-30, DB-90
- Hart Acupad, Hart Hammer, Pintech Dingbat, Sony MDR-7505, Shure E2, 512. Pacific CX, Zildjian A Customs.
-
04-13-12, 02:19 AM #3
Silver Contributor
- Join Date
- 07-2008
- Location
- Melbourne, Australia
- Posts
- 256
And if all that yeilds no result try new cables. I have found my HH CTRL cable is damaged somewhat and in the wrong position can randomly cause the HiHat to open and close.
Roland TD-20 (Expanded TDW20) stock standard kit setup + KD7, HPD 15, Alesis Trigger I/O, X2 Mandala pads, DrumKat 3.7, MacBook Pro 2011 i7, 8GB Ram, x2 SSD. RME Babyface
Battery 3, Sonic Coutures Hang drum, ToneHammer Tabla Vol 2 "Multi", BFD2 - Sleishman expansion pack.
Ableton Live
Student of Thomas Lang's drum academy at http://www.artistworksdrumacademy.com/
My band [urlwww.onshiftingsands.com/[/url]
Reply With Quote